BLACK ANTI-WEED MESH 1.50x20mt 130grs.

Two-component PU adhesives consist of a resin (component A) and a hardener (component B), mixed in a defined proportion. of two-component adhesive.

5KG can.

The adhesive performance is approximately 0.40/0.60 kg of adhesive per M2.

All our adhesives are certified according to UNE-EN 13744:2006 and UNE-EN 12228:2002 regulations required by FIFA for the installation of artificial turf in accredited and approved sports fields and facilities.

• Silica sands are the most ecological and natural in Spain, free of chemical products (amines and hydrofluoric acid) and without salinity. Washed exclusively with natural waters and dried with biomass.
• They are characterized by being aeolian, round or spheroid sands, without edges, allowing the product not to cake or compact, facilitating drainage. Granulometries: 0.2-0.5s/ 25kg

SILICA PALLET 1,200kg – 48sacksx25kg

Two-component PU adhesives consist of a resin (component A) and a hardener (component B), mixed in a defined proportion. of two-component adhesive.

12KG can.

The adhesive performance is approximately 0.40/0.60 kg of adhesive per M2.

All our adhesives are certified according to UNE-EN 13744:2006 and UNE-EN 12228:2002 regulations required by FIFA for the installation of artificial turf in accredited and approved sports fields and facilities.

Joint tape for the installation of turf.

0.15x25mt roll.

Anti-weed textile mesh, made of polypropylene.

Resistant to dry rot and fungal attacks.

It is applied as an anti-weed sheet, placed under vegetable or mineral mulching.

2x100mt

Special pegs for artificial turf.

Pack of 100 units.

Seaming tape for lawn installation.

0.30x25mt roll.

Pine wood treated in autoclave with class 4 vacuum-pressure against woodworm, termites, and insects. Planks of 1940 × 95 × 45mm.

Anchor set for the installation of Speziala lines: II

18 stainless steel tubular anchors

• 8 pieces with 4 cm anchors

10 pieces with 5 cm anchors.

• .• Model: 10 cm
• Sector configuration: from 40° to 360°
• Factory-installed rubber cover
• Top-side sector adjustment
• Quick sector verification mechanism
• Water-lubricated gear drive
• Nozzle types: 27 in total
• Nozzle sets: #1 to #12 red, 1.5 to 8.0 blue, #4 LA to #10 LA gray
• Warranty period: 2 years

Range: 6.7 to 13.7 meters.
Pressure: 1.7 to 4.1 bar.
Flow rate: 0.34 to 1.91 m3/h.

• Double female thread lower inlet: ½” (15/21) and ¾” (20/27)

Female side inlet: ½” (15/21)
Trajectory angle:

23° for nozzles No. 06, 07, 08, 10 and 12
11° for nozzles 07-LA and 10-LA

• MPR Nozzles: 06 (red), 07 (black), 08 (blue), 10 (yellow), 12 (beige)
• Low angle nozzles: 07-LA (black), 10-LA (yellow)