Handball net

3x2mt shock-absorbing net in polypropylene.

Knotless square mesh, 100mm, knotless

3 and 4mm thick mesh.

Different colors.

Seaming tape for lawn installation.

0.30x25mt roll.

Fountain with a sober structure, square iron body with Ferrus treatment to prevent corrosion.

Finished with epoxy primer and gray hammered powder polyester paint.

Fixing plate-nickel-plated steel push button tap (UM510G). Angular frame and galvanized steel drain grid.

• The Oslo bench is manufactured with ductile iron feet with Ferrus treatment for corrosion protection. Coated with Marson-colored polyester powder paint.
• The five tropical wood planks are treated with a triple layer of Lignus coating, a fungicide, insecticide, and water repellent protector.

All the screws are made of stainless steel.
Recommended anchoring: Using M10 expansion bolts depending on the surface and project.

• Trash can with semi-circular folding steel bucket with triangular holes with Ferrus treatment to treat corrosion. Final coating of gray RAL 7011 polyester powder paint. Bucket supported on a 40 mm tube structure with an anchoring base and rectangular plates with 2 12 mm holes for fixing to the ground.

Measurements: 455mm diameter, 605mm total height.

Recommended anchoring: By means of four M8 expansion bolts depending on the surface and project.

Sober and elegant, the Neobarcino bench is one of the most requested products in the BENITO URBAN range of urban furniture.

It is possible to purchase the Neobarcino Bench with FSC wood, which comes from controlled logging, or in technical wood.

We add the possibility of customizing the Neobarcino Bench with a permanent marking that identifies the Urban Furniture of your municipality.

THE ORIGINAL HAS THREE COATS OF PAINT AND A PROTECTIVE ANTI-CORROSION TREATMENT.

The NEOBARCINO is a bench manufactured with ductile iron feet treated with Ferrus, an iron protection process that guarantees a

optimal resistance to corrosion. The Ferrus treatment consists of three layers that are applied after cleaning all dirt and

impurities by shot blasting and consists of an electrolytic bath, followed by a layer of epoxy primer and a final coating of

gray-hammered polyester powder paint.

The six tropical wood planks are treated with the Lignus triple-layer coating, a protective fungicide, insecticide, and water repellent.

All the screws are made of stainless steel.

Recommended anchoring: By means of M10 expansion bolts according to surface and project.

BASIC BADMINTON C-PVC SUPERIOR

-Size: 1.85×1.22m

-Made with High Tenacity Polypropylene Thread.

-2mm thick net, 18mm mesh width.

-White PVC top band, black polyester trim on the sides and bottom of the net.

-One eyelet in each upper corner of the net and double tension cord of 0.3mm.

-0.4mm plasticized steel cable.

* Also available in BASIC BADMINTON C-PES SUPERIOR and HIGH COMPETITION BADMINTON C-PS SUPERIOR.

• Chemical product composed of flakes that dissolve on the court, forming a waterproof solution down to -10ºC, European manufacturing.
• WINTER. With proper treatment, the courts are prevented from freezing and remain usable throughout the winter, avoiding deterioration, which would involve the compaction of the softened ground.

SUMMER. Absorbs ambient humidity, keeping the court moist without the need for watering.

• PALLET OF 1250KG 50 bags of 25kg.

Prefabricated lines of white cement and marble sand.

With 2 galvanized iron rods inside.

• 32 wide lines of 5.5cm + 92 narrow lines of 4.5cm.
• Line length: 1.20 meters.

Range: 6.7 to 13.7 meters.
Pressure: 1.7 to 4.1 bar.
Flow rate: 0.34 to 1.91 m3/h.

• Double female thread lower inlet: ½” (15/21) and ¾” (20/27)

Female side inlet: ½” (15/21)
Trajectory angle:

23° for nozzles No. 06, 07, 08, 10 and 12
11° for nozzles 07-LA and 10-LA

• MPR Nozzles: 06 (red), 07 (black), 08 (blue), 10 (yellow), 12 (beige)
• Low angle nozzles: 07-LA (black), 10-LA (yellow)