Replacement court sweeper

2 Layers of fine mesh PVC material, with final finish

Length: 1.15m

Aluminum ruler

Working width: 2m

2 Layers of fine mesh PVC material, with final finish

Length: 1.15mts.

Wooden ruler

Working width: 2 mts.

Very light.

Aluminum profile.

Aluminum handle

High-strength rigid rubber

Working width: 100cm.

– For water collection

– To remove grit from the court

– For working damp soil.

Galvanized solid iron tamper or rammer.

Wooden handle.

For small court repairs and tablet pressing.

Working surface: 20x20cm.

• For scraping tennis courts and removing leaves.
• Ideal tool for spring and autumn season.
• Aluminum U-profile, in which the steel wire bristles are incorporated, which allows collecting leaves, moss or other dirt.

With the steel wire brush, you can scratch and loosen the hardened layer that forms in winter due to frost and snow.

Aluminum arch with a plastic coating in the handle area, designed to receive sufficient pressure along the entire length of the broom, performing the work with little effort.

Length: 200 cm

Guide rod width: 5 cm

Guide rod height: 3 cm

• Bristle height; 7.5 cm

Bristle distance: approx. 1 cm

• Weight: approx. 5.7 kg

Working width 200 cm.

Bucket with galvanized grid and sponge with aluminum handle.

To absorb small puddles on the court.

There is a replacement for the foam

For filling holes and leveling irregularities.

Working width 100 cm wide.

With wooden handle.

Aluminum rake with soft rubber teeth

Wooden handle.

For collecting leaves and surface dirt from the court.

Width: 75cm.

• Trash can with semi-circular folding steel bucket with triangular holes with Ferrus treatment to treat corrosion. Final coating of gray RAL 7011 polyester powder paint. Bucket supported on a 40 mm tube structure with an anchoring base and rectangular plates with 2 12 mm holes for fixing to the ground.

Measurements: 455mm diameter, 605mm total height.

Recommended anchoring: By means of four M8 expansion bolts depending on the surface and project.

• Steel bicycle rack with Ferrus anti-corrosion treatment. The Ferrus treatment involves applying an electrolytic bath to the piece, followed by a layer of epoxy primer and finally a coating of gray RAL 9006 powder polyester paint.

Recommended anchoring: Using 4 M8 expansion bolts, depending on the surface and project.

Prefabricated lines of white cement and marble sand.

With 2 galvanized iron rods inside.

• 32 wide lines of 5.5cm + 92 narrow lines of 4.5cm.
• Line length: 1.20 meters.

Replacement court sweeper. 90cm

• Polyester guide center
• Aluminum carabiner.

Plastic adjusting buckle