Wide cement line

Line marker for precision lines, especially for marking on artificial and natural grass.

Maintenance-free.

No Maintenance or Cleaning Required

Ergonomic handle.

Comfortable start-up trigger

Tracing width adjustment: 3 to 10 cm.

The aerosol can holder is reinforced

The wind guard ensures perfect marking

Highly resistant reinforced metal chassis.

Lateral support for marking at the edge of pallets, machines, walls, etc.

Aerosol can compartment for quick paint availability

Includes tracing cord and can of az

Flexible profile made of hard PVC, white color

Transverse grooves 4 mm wide, at 28 mm intervals.

18 pieces of anchor pipe

4 rolls of 24 m = 4 cm

1 roll of 22 m = 5 cm wide

• 1 roll of 30 m = 5 cm wide
• Material needed for the installation of a court, which can be done by one person
• * The use of hard PVC and cross slits results in excellent anchoring with the surface of the court.

• Galvanized ratchet tensioner with fastening anchors and special straps for tensioning the Speziala tennis line.

Special paint for floors, highly resistant and with high pigmentation.

– Resistant to traffic, inclement weather, and hydrocarbons.

– Quick-drying paint.

– CFC and lead-free paint.

– 7 colors available.
Price per box of 12 units

Prefabricated white cement lines, with 2 galvanized iron rods inside.

Width 5 cm.

Length 1.20 meters.
Sold per unit.

Anchor set for the installation of Speziala lines: II

18 stainless steel tubular anchors

• 8 pieces with 4 cm anchors

10 pieces with 5 cm anchors.

Prefabricated lines of white cement and marble sand.

With 2 galvanized iron rods inside.

• 32 wide lines of 5.5cm + 92 narrow lines of 4.5cm.
• Line length: 1.20 meters.

2 Layers of fine mesh PVC material, with a final finish

Length: 1.15m

Aluminum ruler

Working width: 3m

WIDE YELLOW BRUSH 1MT

Wooden support 1040x65mm

1.2mm polyprotylene bristles

Galician wood handle attached with metal clip.

Working width 1mt.

To remove dirt after rain.

• Barcelona 1″ threaded aluminum fitting for lance or nozzle.

Female or male

Range: 6.7 to 13.7 meters.
Pressure: 1.7 to 4.1 bar.
Flow rate: 0.34 to 1.91 m3/h.

• Double female thread lower inlet: ½” (15/21) and ¾” (20/27)

Female side inlet: ½” (15/21)
Trajectory angle:

23° for nozzles No. 06, 07, 08, 10 and 12
11° for nozzles 07-LA and 10-LA

• MPR Nozzles: 06 (red), 07 (black), 08 (blue), 10 (yellow), 12 (beige)
• Low angle nozzles: 07-LA (black), 10-LA (yellow)

Set of two cylinders with metal spikes.

Galvanized and oven-dried painted finish.

Easy adaptation to the motor hoe.

Ideal for milling the court, does not lift the rubble.

Axle included.